Solvent-free injection concentrate, based on synthetic resins. It is used to make a horizontal diaphragm to cut off capillary moisture. The preparation can be used even at a very high degree of salinity and moisture. The product is flexible after hardening. It can be used in self-dispensing systems - in special cartridges.

Properties

• solvent-free
• very low viscosity
• based on synthetic resins
• penetrates deeply, also into the finest capillaries
• Due to the much lower surface tension than water, the preparation has the ability to displace water from pores and capillaries in building materials
• capillaries after application of the preparation acquire hydrophobic properties
• the effectiveness of the injection concentrate is independent of the degree of moisture and salinity of the wall
• almost odorless
• remains flexible after curing
• not corrosive to reinforcing steel
• does not cause an exanthema
• resistant to all aggressive substances usually present in the walls, such as diluted bases, acids and salts, both in the application phase and after hardening
• in accordance with WTA guidelines - effective in leek moisture up to 95%

Application

• injection of an element in a structure made of mineral material (except for plaster walls) in order to recreate a horizontal insulation against capillary rising moisture
• the material in the system with capillary rollers is dedicated to injection in walls with voids, e.g. perforated brick, grid brick, ceramic blocks, silicate brick, etc.
• The concentrate can be used both indoors and outdoors, even with a high degree of salinity and moisture

Technical data

• density 0.91 g / cm ³
• method of operation: narrowing the pore diameter w / hydrophobization
• viscosity 10-15 mPa s
• solids content 70%
• consumption 0.04 l / m per 1 cm of wall thickness