Qmar - žemo slėgio žarnos putos
kaina pagal užklausimą
kainoraščio kaina
vieneto grynasis
6.59EUR už vnt
reklaminė kaina
vieneto grynasis
6.17EUR už vnt
minimalus komercinis
produkto kiekis
1.00 vnt
visos kainos
grynasis kainoraštis
6.59EUR
už 1.00 vnt
visos kainos
reklaminis tinklas
6.17EUR
už 1.00 vnt
kainoraščio kaina
bruto vienetas 8.11EUR
už vnt
reklaminė kaina
bruto vienetas
7.59EUR
už vnt
minimalus komercinis
produkto kiekis
1.00 vnt
visos kainos
kainoraštis bruto
8.11EUR
už 1.00 vnt
visos kainos
reklaminė bruto
7.59EUR
už 1.00 vnt
Produkto aprašymas
The foam is intended for assembly and sealing for specialized assembly groups.
Application
- especially recommended for all types of windows and doors
- thermal insulation of water, sewage and central heating networks
- bonding and insulating wall panels, corrugated sheets, roofing boards, etc.
- soundproofing and sealing of partition walls and car cabins
- joining prefabricated element in wooden frame construction
- thermal insulation roof in and flat roof in
- filling gaps in thermal insulation when insulating buildings
properties
- the foam has extremely good adhesion to smooth and porous surfaces occurring when installing doors and windows: PVC, masonry, concrete, brick, wood, metal and other
- low-pressure formula eliminates frame warping and ensures full gap filling
- has excellent thermal insulation and soundproofing parameters
- cures under the influence of moisture contained in the atmospheric air
- resistant to mold and mildew
Method of use
- Thoroughly clean and degrease the working substrate.
- Before use, make sure the can is positive (optimum +20 C).
- Shake the can well (for about 30 seconds) to thoroughly mix the ingredient in.
- Screw the applicator to the can, the working position for assembly is the can position "to the top".
- Apply foam from below to the gap.
- Fill the joints up to 50% deep, but not more than 5 cm per one layer, wider than 5 cm should be filled in layers,
- Moisten each layer after application with water, e.g. with a sprayer.
- Excess foam after curing should be removed mechanically (e.g. with a knife).
- After full hardening, the foam should be protected against UV rays using plaster, paints, for example.
Techniniai duomenys - savybės
- efektyvumas (laisvas putojimas):
- do 45 L
- laikymo temperatūra:
- od +15 do +25 ° C
- matomas tankis:
- 19 ± 10% kg / m³
- nustatymo laikas:
- 2 - 24 h
- šiluminė varža po sukietėjimo:
- od –60 do +100 ° C
- spalva:
- kremowy
- pakuotė [ml]:
- 750 ml
priedai